General Information For Use; Preparation For Use - Dräger UCF FireVista Manual Del Usuario

The thermal imaging camera can be used, e.g., to support
– the search for and rescue of people
– Assessments of the situation and keeping fire watch
– Assessments of the fire area
– Locating the fire source
– Identifying hot spots
– Identifying potential flash over situations
– Locating entry, exit and ventilation points
– Accidents with hazardous substances
– Large-scale, forest and bush fires
– Monitoring tasks
– Training
The thermal imaging camera can be used in fires and hazardous situations, and
in normal environments. The thermal imaging camera is designed for use in
heat, smoke and spray water.
3.4 Limitations on intended use
The thermal imaging camera cannot see through glass or water. Shiny and
glossy surfaces (e.g. metal, glass) reflect thermal radiation and can lead to loss
of orientation if the user is not properly trained in using the camera.
The thermal imaging camera is not a life-supporting device and must therefore
not be used as such.
The thermal imaging camera is not intended for precise temperature
measurement. The indicated temperature may be different from the actual
temperature.
3.5 Approvals
Refer to document 9300651 for specific information on individual approvals.
Declaration of conformity: www.draeger.com/product-certificates
Instructions for use |
Dräger UCF FireVista
4 Use
4.1

General information for use

WARNING
If the thermal imaging camera is used as the sole navigation source, a
malfunction can result in a loss of orientation, injury or even death of persons.
► Do not use the thermal imaging camera as the sole navigation source.
– Charge the rechargeable battery immediately after receiving the thermal
imaging camera to prevent deep discharge.
– The operating time of every rechargeable battery will be reduced if used in
environments with high or very low temperatures.
– The thermal imaging camera is a complex electro-optical device and may
exhibit malfunctions like any other electronic system. In the event of a
camera failure, the user will not receive any more thermal images. When
using this thermal imaging camera on tactical missions, follow the
procedures that have been put in place for operations without a thermal
imaging camera.
– All users must familiarise themselves with the proper function and the
performance limits of the thermal imaging camera before use. This includes
general understanding of thermal images and how they are interpreted.
Dräger recommends Dräger Academy or third-party training, e.g., at a
firefighter school. Contact Dräger for additional information.
– The thermal imaging camera may only be used by persons who are familiar
with its use and performance limits. This includes use under simulated fire
conditions (e.g. controlled fire situations).
4.2

Preparation for use

1. If required, fasten the retractable lanyard to one of the two lugs.
2. Fully charge the rechargeable battery in the thermal imaging camera (the
LED on the charging cradle will then light green).
3. Visually inspect the thermal imaging camera: There must be no damage
present.
4. If necessary, use a soft cloth to wipe any condensed moisture from the
window of the IR camera.
| en
Use
13