Troubleshooting - Timberpro BLO-200 Manual Del Usuario

English

9. Troubleshooting

Depending on the symptoms you observe, you may detect the cause of the problem and solve it.
The engine does not start:
Cylinder compression is
normal
Yes
Yes
Loss of compression
The engine does not turn
The spark of the
spark plug is
correct
There is no fuel in the tank
There is water in the fuel
Yes The fuel used is not appropriate
The safety switch of the ventilator is loose or
the cover is not closed correctly.
The switch is in the "OFF" position
No
The spark plug wire is not connected.
Piston, parts of the piston, worn cylinder
Yes The cylinder is scratched
Probable cause
The fuel filter is dirty
The carburetor is dirty
The spark plug is dirty
The spark plug is loose
Seized engine
15/109
Corrective action
Add fuel to the tank.
Clean the filter
Change the fuel
Use fuel with an appropriate octane level +
100% synthetic oil
Tighten the safety switch.
TIMBERPRO
Bring your machine to a
authorized dealer
Put the switch in the "I"
position
Clean the spark plug
Connect it
Tighten it
TIMBERPRO
Bring your machine to a
authorized dealer
TIMBERPRO
Bring your machine to a
authorized dealer
TIMBERPRO
Bring your machine to a
authorized dealer