Lubrication; Service; Important; If You Have A Problem - Hoover Brush 'N' Wash Manual Del Usuario

S S t t o o r r a a g g e e
Before storing:
• Empty solution tank and rinse
• Replace empty solution tank and
thoroughly with clean water.
turn cleaner ON. Squeeze
trigger and push cleaner forward
and back several times to expel
any solution remaining in the
cleaner's system. (Do not use
cleaner on wood floors.)
• Empty recovery tank and rinse
Allow brushes and underside of
thoroughly with clean water.
cleaner to air dry thoroughly before
storing cleaner on a carpeted or wood
surface.
Do not store cleaner with a full solu-
tion tank In place.

Lubrication

The motor is equipped with bearings
which contain sufficient lubrication for
cant could cause damage. Do not add
the life of the motor. The addition of lubri-
lubricant to motor bearings.

Service

Use only genuine Hoover spare parts.
Always identify your cleaner by the com-
plete model number when requesting
information or ordering parts. (The
model number appears on the back of
the cleaner handle.)

IMPORTANT

Cord Replacement
This HOOVER appliance is supplied
complete with a plug. For the UK, the
plug is fitted with a 13 Amp fuse.
If the main cord of this appliance is
damaged, the appliance must be
repaired by an Authorised Hoover
Repairer to avoid a safety hazard.
WARNING!
ELECTRICITY CAN BE
EXTREMELY DANGEROUS.
THIS APPLIANCE MUST BE
EARTHED.
If you have a
problem
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below.
Problem: Machine wonʼt run
Possible cause
• Not firmly plugged in
Possible solution
• Plug unit in firmly
• No voltage at electrical socket
• Check fuse or breaker
• Blown fuse/tripped breaker
• Replace fuse/reset breaker
Problem: Low suction
Possible cause
• Recovery tank lid not on correctly
Possible solution
• Make sure lid is on securely (Fig. 32)
• Blockage in nozzle on end of hose
• Remove nozzle and clear blockage
• Recovery tank full/automatic shut
off engaged
• Remove and empty recovery tank
• Recovery tank front panel not
replaced after stair or upholstery
cleaning
• Replace recovery tank front panel
Problem: Clean solution wonʼt (Fig. 41)
dispense
Possible cause
• Solution tank not firmly in place
Possible solution
• Make sure tank is securely locked in
• Solution tank empty
position
• Refill tank according to instructions for
• Recovery tank lid not on
surface being cleaned (Figs. 23-29)
correctly
• Make sure lid is firmly in place (Fig.
• Stair/upholstery solution tube not
32)
securely fastened
• Make sure tube is securely fastened
at hood connection
Problem: Brushes/brush indicator
wonʼt rotate during floor cleaning
Possible cause
• Indicator screen dirty
Possible solution
• Remove clear cover over indicator
and clean screen; replace cover (Fig. 22)
• Speed selector on OFF
• Move speed selector to Low or Hi
• Solution tube connected to "Stair/
upholstery cleaning connection"
• Remove stair/upholstery nozzle for
floor cleaning (Fig. 44)

Guarantee

Statement
The guarantee conditions for this appli-
ance are as defined by our representa-
tive in the country in which it is sold.
Details regarding these conditions can
be obtained from the dealer from whom
the appliance was purchased. The bill of
sale or receipt must be produced when
making any claim under the terms of this
guarantee. Subject to change without
notice.
*HOOVER and are registered
trademarks
15