Menu Settings - ACO Lipujet-P-OAP Instrucciones De Empleo

Grease Separator
Operation

4.2.2 Menu Settings

Settings for some of the menu items can only be made in the service mode, and should be
coordinated with ACO Service.
Select menu items (top line): Turn
Î
Change setting (bottom line),
Î
Confirm a setting: Press button
Î
Menu items
(top line)
Last fault
Pre-cleaning
After-cleaning
Normal level
Lower level
Tank empty
High water level
Heating time (with
an optional heating
rod)
After-run time
54
rotary switch.
section 4.2.3 „Settings for initial operation".
briefly.
Settings
Explanation
(bottom line)
Display of the last fault.
Time taken for pre-cleaning.
After the program has been started the water
switched off
level is lowered to the "lower level".
1-60 min.
Pre-cleaning then starts; layers of hardened
fat are crushed.
Time taken for after-cleaning.
After-cleaning is started after pre-cleaning.
1-60 min.
The tank is cleaned thoroughly during after-
cleaning and the water level is reduced down
to the set zero point for "tank empty".
0-200 cm Pipe bottom discharge water level.
0-200 cm Water level at which "pre-cleaning" starts.
Water level defined as "empty" for "tank
0-200 cm
empty".
Water level at which an alarm is triggered (set
0-200 cm
at the factory).
Heating time. Heating rod must be switched
Is switched off 1- on.
24h The "ON/OFF switch" is located on the right-
hand side of the control unit box.
Specification of time in which the disposal
0-180 sec. pump continues to operate after the water
has reached the "empty tank" level.