Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package and hardware contents
list. If any part is missing or damaged, do not attempt to assemble the product. Contact Customer Service for replacement
parts.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): Tape Measure, Phillips Screwdriver, Hammer, Electric Drill, Drill Bits, Level
Please follow all local electrical codes and consult an electrician when wiring this product.
WIRING DIAGRAM
Installation may vary depending on how the previous mirror was installed and the presence of the power source. Supplies necessary for installation
of your new mirror are not all included; however, most are available at your local home improvement or hardware store.
*House wires may vary in color. Please be sure to verify actual house wires with a certified electrician before installation.
INSTALLATION INSTRUCTIONS
WARNING: Turn off power at circuit breaker or remove fuse
before attempting installation.
1. Determine the midpoint of where the mirror will be installed and
mark with a pencil. Place the Z-bar (DD) on the wall with the
middle hole of the Z-bar (DD) positioned over the midpoint.
Hardware Used
DD
Z-bar
2. Using a level, make sure the Z-bar (DD) is straight and mark the
other two holes on the Z-bar (DD) located to the right and left
sides. Remove the Z-bar (DD).
Hardware Used
DD
Z-bar
Mirror
white
green
black
neutral
ground
live
1
x 1
2
x 1
3
House
Electrical
Wires*
white
green
black
11"
A
5-1/2"
DD
DD
Publicidad
Tabla de contenido
