TRC 1000 Guia De Inicio Rapido página 2

SETTING FEED RATE
(for Variable Speed models only)
When the control panel is turned on the LCD will read "FEED RATE 5-22".
This will determine how fast the webbing will feed through the machine.
5 will be the slowest and 22 will be the fastest. To enter the speed, push the number you
desire and press ENTER.
ENTERING A PROGRAM
1. When the Master Switch is on the LCD will read "LENGTH?". To enter the length
you want say a 10" piece just push 10 on the Keypad and ENTER to for enter. For 10
1/2" enter 10*5 and ENTER. Different thickness of webbing will feed at a different rate
and sometimes becomes necessary to calibrate the machine for a particular type of web.
You may have to program in 10.10 to get the length you want for a 10" piece.
2. After entering the length, "HOW MANY?" will appear on the LCD. Enter the
number of pieces you want, example; 50 ENTER for 50 pieces.
3. "CUT TIME?" will appear on the LCD next. This is the amount of time the Knife
stays down to cut the web. This will vary according to the thickness and the width of the
web. Example; a lightweight material may only take .10 sec to cut where a heavier
material may take .250 sec to cut. Some experimentation is necessary to find the best cut
time for your material. To get .10 sec cut time push *10 after "CUT TIME" appears on
the LCD then push ENTER. When you push the ENTER button after the cut time, all
the data will appear on the LCD and the Machine begins cutting.
(You will have to experiment a little with the time to see what works best with your
webbing.)
4. To stop the Machine during operation and not loose the data you have entered push
the STOP button and hold it down until the Machine stops. If you need to make an
emergency stop push RESET or turn the Master Switch off. By using the STOP button
you will save the program and the count. To resume, just press ENTER and it will
continue with the program you had entered. When you use RESET or the Master Switch
you will loose the program. After you have ran a program and want to run the same
program again you do not have to enter the data again. Just press ENTER and it will run
the same program and continue to keep a running count.
5. When you are through with the Machine turn the Master Switch "OFF".
Cc7setup.wps