Uline OHAUS RANGER 7000 Manual Del Usuario página 3

LEVELING THE SCALE
NOTE: Only scales that have been leveled
precisely horizontally provide accurate
weighing results. The certified scales have a
spirit level to simplify alignment.
1. Turn the adjustable feet of the scale until the spirit
level's air bubble is inside the inner circle.
(See Figure 3)
Figure 3
REMOTE TERMINAL OPERATION
1. The terminal communicates with the weighing base
via the terminal cable. This cable must be plugged
into the terminal for the scale to display properly. If
desired, the scale may be operated either with the
terminal attached, or remotely (up to 1.5 meters away).
SEPARATING THE TERMINAL FROM THE
WEIGHING BASE
1. To detach, press the release buttons inward (both at
the same time) and gently pull the terminal towards
you (outward) until the terminal is detached. These
release buttons disengage the two hooks holding
the terminal to the base. A cable is attached to the
terminal. Take care to not damage or disconnect
this cable. (See Figure 4)
PAGE 3 OF 105
CONFIGURATION SUITE
2. To reattach the terminal, press in the two release
buttons (See Figure 4) and slide the terminal into the
base until the terminal hooks click and engage to
hold the terminal in place. (See Figure 5)
TERMINAL MOUNTING
Release
Buttons
Figure 4
Base
Terminal
NOTE: If desired, the terminal may be mounted
to a wall or table using fasteners (not supplied)
that are appropriate for the type of mounting
surface. (See Figure 6)
1.97"
Bottom of
Terminal
Figure 6
Figure 5
Mounting
Holes
0721 IH-7991