Connections To Be Made - Axxess AX-MB1 Instrucciones De Instalación

(a) From the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness to the
aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the ignition wire.
• Connect the Orange wire to the illumination wire. If the aftermarket radio has
no illumination wire, tape off the Orange wire.
• Connect the Blue wire to the antenna turn on wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
AX-MB1

Connections to be made

(b) ASWC-1 pre-wired harness:
2
®
The following wires are for the aftermarket radios that have navigation built in:
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio (if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire of the
aftermarket navigation radio (if applicable).
• Connect the Green/Purple wire to the reverse wire of the aftermarket
navigation radio (if applicable).
• This harness is to be used in conjunction with the optional ASWC-1 (not
included) to retain steering wheel controls. If the ASWC-1 is not being
used, disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.