Setting Output Data; Setting Door Relay Strike Time; Setting Alarm Signal Output Time; Setting Door Open Detection - PRASTEL Fingerkey Manual Del Usuario

Setting output data

The output programmable data is formed by user ID as
default setting, and could be output with Wiegand 26 or
Wiegand 34.
Press: 3 user ID # new data #
Note
The data must be of 10 digits and within 0000000001-
GB
4294967295

Setting Door Relay Strike Time

The door relay output can be operated as either normally
opened or normally closed, a maximum current of 10 ampere
can pass through the relay if used as normally opened or 5
ampere if normally closed. The door relay time can be set
from 0 seconds to a maximum of 99 seconds. The factory
default setting is 6 seconds and can be changed through the
keypad.
Press: 4 new time from 00 to 99 seconds #

Setting Alarm Signal Output Time

Press: 5 new time from 00 to 99 minutes #

Setting Door Open Detection

Press: 6 0 0 # to disable this function (factory setting)
Press: 6 0 1 # to enable this function.
- 27 -