Setting Format Of Wiegand Output; Exit Engineer Programming Mode; Resetting To Factory Default Setting; How To Release The Door - PRASTEL Fingerkey Manual Del Usuario

Setting format of Wiegand output

Press: 9 0 0 # output with Wiegand 26 (factory default
setting).
Press: 9 0 1 # output with Wiegand 34

Exit Engineer Programming Mode

GB
All the setting completed, press * to exit engineer
programming mode.

Resetting To Factory Default Setting

To revert all settings to the factory default values, but all of
the users data is secure.
Reset Non Volatile Memory by switching of the power and
placing the jumper connector onto the pins 1 & 2 as per
figure 5. After switching power on remove jumper, the
Fingerkey will give a beep and is now reset to factory default
values.

How to release the door

Use fingerprints to release the door
Put the finger on the fingerprint senor for 1 second.
Use code and ID to release the door
Press: user code # user ID #
- 29 -