To Throw Snow - Craftsman 536.881851 Manual Del Usuario

The operation of any snow thrower can
result
in foreign objects being thrown
into the eyes, which can result in se-
vere eye damage. Always wear safety
glasses or eye shieldswhile operating
the snow thrower.
We recommend standard safety
glasses or a wide vision safety mask for
over your glasses.
A ARNING: Read Owner's
Manual before operating
machine. Never direct dis-
charge toward bystanders. Stop the
engine before unclogging discharge
chute or auger housing and before
leaving the machine.
TO STOP YOUR
SNOW THROWER
1. To stop throwing snow, release the
auger drive lever.
2. To stop the wheels, release the
traction drive lever.
3. To stop the engine, pull out the
safety key.
CAUTION: To stop the engine, do not
move the choke control to CHOKE
position. Backfire or engine damage
can occuh
TO CONTROL SNOW DISCHARGE
1. "rum the chute control rod to set the
direction of the snow throwing.
2. Loosen the wing knob on the chute
deflector and move the deflector to
set the distance. Move the deflector
(Up) for more distance, (Down) for
less distance. Then tighten the
wing knob (See Figure 10).
Wing Knob
HOW TO MOVE FORWARD AND
BACKWARD
1. TO shift, release the traction drive
lever (left hand) and move the
speed shifter lever to the speed you
desire. Ground speed is deter-
mined by snow conditions. Select
the speed you desire by moving the
speed shifter lever left into the ap-
propriate notches on the shift lever
plate:
Speeds 1,2 - Wet, Heavy
Speed 3 - Light
Speed 4 - Very Light
Speed 5,6 - Transport only
2. Engage the traction drive lever (left
hand). As the snow thrower starts
to move, maintain a firm hold on the
handles, and guide the snow throw-
er along the clearing path. Do not
attempt to push the snow thrower.
3. To move the snow thrower back-
ward, move the speed shifter lever
right into first or second reverse and
engage the traction drive lever (left
hand).
IMPORTANT: Do not move the speed
shifter lever while the traction lever is
down.
TO THROW SNOW
1. Push down the auger driver lever
(right hand).
2. Release to stop throwingsnow.
TO USE WHEEL LOCKOUT PIN
,
The right hand wheel is secured to
the axle with a klick pin. This unit
was shipped with this klick pin in the
locked position (through wheel
hole). See Figure 11.
Klick Pin
ure 10
Locked
Position
2-Wheel
Drive
Figure 11
12