Tripp-Lite U339-E02 El Manual Del Propietario página 4

Operation
Note: If the SATA hard drive has not been formatted, it must first be
formatted using a computer Disk Management utility in order to access
drive contents.
1. Connect the included power supply to the docking station,
then to an available wall outlet or a Tripp Lite Surge Protector.
2. Insert a 2.5" or 3.5" SATA hard drive into an available bay on
the docking station, making sure it is securely seated on the
SATA connector. Repeat this step to connect an additional
hard drive.
3. Connect the included USB 3.0 cable to the docking station
and a computer.
4. Use the ON/OFF switch on the back of the unit to power the
docking station. The red Power LED will illuminate to indicate
power is being received. The red drive bay LEDs (HDD1 &
HDD2) will illuminate to indicate a hard drive is connected
to the corresponding port and blink when data is being
transferred.
19-07-475-9339DF.indb 4
4
8/28/2019 3:37:31 PM