Wall Mounting - Tripp-Lite PSF2408 El Manual Del Propietario

Wall Mounting

All Power Strip models feature clips for horizontal or vertical mounting on a variety of surfaces.
The user must supply other mounting hardware (screws, etc.) and determine its suitability for use
with the chosen mounting surface.
1
Mark a straight horizontal or vertical line where
you want to mount the Power Strip. At each end
of the line, mark where the edges of the Power
Strip will be located. Place a mounting clip on
the mounting surface 1" in from these edges
and mark where the screws must be driven into
the wall. For strips longer than 48" (120 cm),
also mark a screw hole for a third mounting clip
midway between the other two.
2
Clip Mounting: Drive #10 screws through
washers, through the centers of the mounting
clips and into the mounting surface
the Power Strip inside one edge of the mounting
clips, then snap the Power Strip into place
Specifications
Model
PSF2408
PSF3612
15-01-151-933414.indb 3
2a
Amperage Outlet
Rating Qty. x Type
15A 8 x 5-15R
15A 12 x 5-15R
1
. Place
2b .
2a
2b
Input Plug Cord Length
5-15P 15 ft.
5-15P 15 ft.
3
Overall
Length Breaker
24 in. 15A
36 in. 15A
1/30/2015 2:16:22 PM