Descargar Imprimir esta página

Malossi MHR Team II Manual De Instrucciones página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

terminal of the new system
6).
• Yellow wire for engine kill switch.
• Connect the yellow wire to the
switch (NOT included in the kit),
ground the switch.
• This is not a necessary
connection for the correct
operation of an ignition with an
internal rotor.
Timing check with
stroboscope gun for all the
vehicles
If you have a good stroboscope
gun with a display to read the spark
advance degrees, you can make a
dynamic check as follows.
• Drive the motor to its top dead
centre and, by using a thin tip
pen or a drawpoint, mark on the
rotor and on the stator a line
Fig.
4.
• Remove the dial indicator, fit the
(Fig.
spark plug, select map 0 and
connect it to the high-voltage
cable.
• Connect the stroboscope gun
and start the engine stabilizing it
at 4,000 rpm.
• By using the gun collimator align
the reference mark on the stator
with the mark drawn on the rotor.
• If all the operations were
properly performed, the
gun display should show the
advanced angle as indicated in
(± 2° degrees).
Table 1
In order to have a good ignition,
take care to check that the distance
between electrodes of the spark
plug is 0,6 / 0,65 mm.
Assemble the fan driving flange and
the Malossi cooling fan onto the
rotor. Re-assemble the original air
manifold.
We hope you found the above
instructions suff iciently clear.
However, if any points are not
particularly clear, please contact
us completing the special form
inserted in the "contact" section on
our Internet site
(malossistore.com). We thank
you in advance for any comments
and suggestions you may wish to
send us. So goodbye from us all
at Malossi, and please accept our
compliments. Have Fun. GOOD
LUCK and ... see you next time.
The descriptions in this publication
are not binding. Malossi reserves
the right to make modifications, if
it considers them necessary, and
does not accept any responsibility
for any typographic or printing
errors. This publication replaces
all previous publications referring
to the updating matters contained
therein.
11

Publicidad

loading