Style selections DETA288-92 Instrucciones De Instalación página 7

HANGING METHOD ASSEMBLY INSTRUCTIONS
4. Hanging Rail Method – If necessary, place 1/16 in.
thick shims (not included) where the left side panel
(A) and right side panel (B) will rest on the shower
base. Lift and hang the left side panel (A) and right
side panel (B) onto the hanging rails (C) mounted on
the wall studs, approximately 1 in. from the back
panel assembly. Confirm correct fit, then slide left
side panel (A) and right side panel (B) on hanging
rail (C) away from back wall to expose back wall
groove.
Apply a continuous bead of silicone adhesive (E)
to the entire length of the groove at the open end of
the back wall panel. Then, slide the left side panel
(A) and right side panel (B) into the groove of the
back wall panel. Clean up excess silicone adhesive
(E) with denatured alcohol (not included) while
silicone adhesive (E) is still wet.
FINAL ASSEMBLY INSTRUCTIONS
1. The unit requires sealing of the joints with silicone
adhesive (E). All joints have been sealed during
installation; however, the perimeter of the shower
base where the panels meet the shower base
requires silicone adhesive (E). Clean the area to be
sealed with denatured alcohol (not included). Seal
with a uniform consistent bead of silicone adhesive (E).
OPTIONAL: The extended shower arm (D) can be
substituted in place of a standard shower arm to
compensate for additional wall thickness.
4
A
1
7
C
B
C
E
Lowes.com