WATERLOO HYPER TOUGH Manual De Usuario página 3

CAStER INStALLAtIoN (40-INCH WIDE CABINEt)
Items Needed:
1/4 - 20 x 5/8 Screw (Qty: 16)
1/4-in Nut (Qty: 16)
7/16-in Wrench
3/8-in Wrench
process:
NotE: use adequate personnel for this operation.
• Remove the bottom drawer by following the drawer
removal instructions in the Operation section.
• Lay the cabinet down on its back. Use packaging
material to protect the paint finish.
• Attach the casters using (4) screws and (4) nuts per
caster. Mount both swivel casters on the same side of
the unit as the side handle.
• Wrench tighten all screws.
• Return the unit to its upright position.
• Reinstall bottom drawers
1/4-20 x 5/8-in Screw
1/4-in Nut
REMovING DRAWERS
• empty the drawer.
• Fully extend the drawer.
Left Release Lever
• Push the lever on the right slide down, lift the lever on
the left side up. Pull out drawer to remove.
INStALLING DRAWERS
Ball-bearing slides - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
3
opERAtIoN
Right Release Lever
slide