Surface Protection - Dacor DTI36M977BB Manual Del Usuario

Maintenance
To remove sugary spills and melted plastic
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can produce
pitting on the surface of your cooktop. This is not covered under the Warranty. You must
clean the spills while they are still hot. Use caution when removing hot substances.
1. Turn all burners off. Remove any hot cookware.
2. Wear an oven mitt, and then use a single-edge razor-blade scraper to move the spills
to a cool area of the cooktop. Remove the spills with paper towels.
CAUTION
• Any remaining spillover must remain until the surface of the cooktop has cooled down.
• Do not use the burners again until all the spills have been completely removed.
• When using a scraper, be sure it is new and the razor blade is sharp. Do not use a dull
or nicked blade.
NOTE
If there are pitting or indentations in the glass surface, the cooktop glass must be
replaced. If this is the case, call for service.

Surface protection

To prevent unintended marks and scratches
• Do not use glass cookware. It may scratch the cooktop.
• Do not place a trivet or wok ring between the cooktop and a pan or wok. These items
can mark or scratch the cooktop.
• Make sure the cooktop and the cookware bottom are clean.
• Do not slide metal cookware across the cooktop.
To prevent stains from building up
• Do not use a soiled dish cloth or sponge to clean the cooktop surface. A film will
remain, which may cause stains on the cooking surface after the area is heated.
• Continuously cooking on a soiled surface can result in permanent stains.
58 English
NZ9500K_MOD_DTI36M977BB_DG68-00899A-02_EN+MES+CFR.indb 58 2017-08-01 12:01:24