Before Use; Check That The Blade Guard Is Functioning Correctly; Initial Operation; Fitting/Changing The Saw Blade - Parkside PHKS 1350 C2 Traducción Del Manual De Instrucciones Original

Before use

Check that the blade guard is
functioning correctly
WARNING! RISK OF INJURY!
■ Switch off the appliance and pull out the
power plug before starting any work on
the appliance.
■ Make sure that all moving parts of the blade
guard move freely without jamming and all
devices designed to cover the saw blade are
working correctly.
■ Activate the blade guard
release lever for the blade guard
♦ Pull the release lever for the blade guard
all the way back.
When you let go of the release lever for the
blade guard , the blade guard
move freely back to its starting position.

Initial operation

The PHKS 1350 C2 circular saw has Intelligent
Power Control. This automatic power delivery
system ensures that for a particular speed range
the power output remains constant when working
on harder and more resistant materials.

Fitting/changing the saw blade

NOTE
► All blades used should conform to EN 847-1.
■ Use only saw blade with diameters corre-
sponding to the label on the saw.
Always pull out the plug from the mains before
changing the saw blade
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
lever and put the device down.
3. Press the spindle lock button
and use the Allen key
screw/washer . Now remover the clamping
screw/washer and the clamping flange
(see also Fig. A).
│ GB │ IE
■ 22
only using the
.
must
!
back using the release
(until it engages)
to release the clamping
Fig. A: Changing the saw blade
4. Remove saw blade
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the Allen key
screw/washer
WARNING!
► The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
device).
■ Ensure that the saw blade
rotational speed of the tool.

Mounting/setting the guide fence

♦ Loosen the wing screw
fence into the guide fence slot
♦ Set the desired cut width with the help of the
scale on the guide fence
arrow in the base plate
)
♦ Fig. B: Cutting width 3 cm
♦ Retighten the wing screw
.
is carried out in the
(until it engages)
to tighten the clamping
.
must corre-
is suitable for the
and insert the guide
.
and the marking
(see also Fig. B).
.
PHKS 1350 C2