Denver Electronics JST-9200 Manual Del Usuario página 6

connected to the correct battery terminal. Then, press and hold the
force start button for 3 seconds to start your car. When the indicator of
the smart clamp lights up green, you need to start the vehicle within
30s.
Step 4: Once your car is started, remove the battery clamps from the car
battery and the jump starter within 30 seconds.
In the following situations, the smart clamp turns protection on.
LED Indicator
The red and green LED
flash in turn
The green LED is always
on
The red LED is always on
Situation
Ready to work.
Work status.
1. Battery clamps are reversed.
- Check whether the clamps are reversed.
2. The clamp is short-circuited.
- Check whether the two clamps touch each