Denver Electronics JST-9200 Manual Del Usuario página 7

The red LED flashes slowly Reverse charging protection, the voltage of the
The red light
quickly
The green LED flashes
slowly
Safety Precautions
Use the original smart battery clamps to start the car.
1.
2. Do not use this unit if any cable, clamp or cord is damaged.
Do not connect two clamps together when the product is turned on.
3.
Do not connect both cable clamps to the same piece of metal.
Otherwise, the jump starter will be damaged.
Care and Maintenance
1. Do not use the product to start a bulging car battery.
Store the product in a cool, well-ventilated area.
2.
Handle the product with care and do not abuse it. Avoid dropping or
3.
other or if both clamps touch the same piece of
metal.
car battery is higher than 12.6V.
- No jump starter needed, the car battery can
start your car.
flashes The temperature of the clamp exceeds 65 (+/-5)
°C.
- Remove the clamp until the red and green LED
flash in turn.
The voltage of the jump starter is too low.
- Try to replace the jump starter or charge it in
time.