Pfc-T Control Panel; Variation The Parameters - Calpeda PFC-T 11 Instrucciones Originales De Uso

3.1. PFC-T control panel

The pump functions are entirely controlled by the
PFC-T electronic control unit.
The user may input and change the values or
access the programming parameters by using 6
pushbuttons. The set values and relative function
messages are shown on the 2 x 16 character
display.
- (programming). This pushbutton is
used to
programming parameters
- (automatic-stop). This pushbutton is
used to alter the pump status. If the
pump is
pushbutton is pressed the pump
transfers to automatic functions and
vice versa.
- (manual). When this pushbutton is
pressed the pump works manually,
even without the pressure switch or
float signal. The pump stops when the
pushbutton is released. If the pump
stops because there is no water, when
the MAN pushbutton is pressed the
pump will not start.
- During programming this pushbutton is
used to move from one parameter to
the next and to increase the set value.
- During programming this pushbutton is
used to move from one parameter to
the previous one and to decrease the
set value.
8
access and exit
on STOP, when
P461.REV01
- ENTER – RESET pushbutton.
The ENTER function is automatically
enabled
functions are accessed. When this
pushbutton is pressed, you enter a
parameter that needs setting or
changing. After inputting or changing
the value, press ENTER again and the
new setting is stored.
The RESET function is enabled during
normal functions and is used to reset
the
the alarms and restart the pump
functions.
- Display 2 x 16 character. Used to display the
programming parameters and the alarms
this
3.1.1. Variaton the parameters
To change the programming parameters:
- Press the
between 01 and 11 appears.
- Use the
move onto the parameter that needs changing.
- Press
the set value will begin flashing.
- Use the
change the setting.
- Press
- Press the
move to any other parameters that need
changing and repeat this procedure.
- When the changes are complete, press the
PROG
programming function.
when the
PROG pushbutton. A parameter
+ and - pushbuttons to
ENTER to access the parameter,
+ and - pushbuttons to
ENTER to store the setting.
+ and - pushbuttons to
pushbutton
programming
to exit the