Battery Installation - Textron JACOBSEN InCommand Eclipse 2 118 Manual Del Distribuidor

4 BATTERY POWER MODULE SET UP
4.4

BATTERY INSTALLATION __________________________________________________

The batteries should be placed into the battery tray as
shown in Figure 4A. Using batteries with the correct
physical size will prevent movement, but will not be tight
enough to cause distortion of the battery case.
Inspect all wires and terminals. Clean any corrosion from
the battery terminals or the wire terminals with a solution
of sodium bicarbonate (baking soda) and brush clean if
required.
Use care to connect the battery wires as shown in Figure
4B and tighten the battery post hardware securely.
Protect the battery terminals and battery wire terminals
with a commercially available protective coating.
Battery Pack Assembly:
1. Install batteries into battery tray.
2. Fasten fuse cable assembly (D) to battery pack with
screws, lockwashers, and nuts.
3. Fasten two cable jumper wires (E) into their
respective positions.
4. Thread the main cable (F) through the hole in the
side of the battery case lid (G).
5. Attach the main cable (F) to the batteries, and
battery monitor (M).
NOTE: There will be an Orange/Green wire with
insulated 1/4" terminal that is not used on the Eclipse
mowers. Seal end of the wire to prevent short circuiting.
6. Assemble the two halves of the battery case (G)
and (H), with screws (J), flat washers (K), and
battery casing straps (L).
Refer to Section 4.3 for battery specifications.
!
WARNING
Aerosol containers of battery terminal protectant must
be used with extreme care. Insulate the metal
container to prevent the metal can from contacting
battery terminals which could result in an explosion.
24
BK Wire
P
Og/Gn Wire
N
RD Wire
F
E
D
G
F
Figure 4A
KEY
F
Figure 4B
J
K
H
L
Figure 4C
E