Starting Procedure - Swisher E4-HT3000 Manual Del Propietario - Operador

Starting Procedure

Engine ignition is controlled by a two-position on-off switch mounted on the throttle
body. This switch is typically labeled "I" for ON and "O" for OFF.
Figure 4
1. Move the ignition stop switch to the rear
(towards the grip) to the "I" or ON posi-
tion. See Figure 4.
Fast Idle
Button
Figure 5
. Set the throttle trigger to the "fast idle"
position by performing the following:
a. Depress and hold the throttle lock,
and then squeeze the throttle trigger.
b. Depress and hold the "fast idle" but-
ton.
c. While depressing the fast idle button,
release the throttle lock and throttle
trigger.
WARNING!
KEEP CLEAR OF THE CUTTING
ATTACHMENT DURING START-
ING OPERATIONS! THE CUTTERS
MAY MOVE WHEN THE ENGINE IS
STARTED!
n Place the trimmer on the ground
during all starting operations.
n Make sure you have a secure foot-
ing, and keep a firm grip on the unit
as well.
n Keep all bystanders and pets well
clear of the trimmer during starting
operations.
6
IMPORTANT!
Ignition ON
Primer Bulb
(viewed from
Ignition
rear)
Switch
Figure 6
3. Prime the carburetor by repeatedly
depressing the carburetor primer bulb
until clear fuel can be seen flowing
through the transparent primer bulb.
The primer system only pushes fuel through
the carburetor. Repeatedly pressing the
primer bulb will not flood the engine with fuel.
Throttle
Lock
Choke
Throttle
Closed
Trigger
Figure 7
4. (Cold engine only) Choke the engine
by moving the choke lever forward to
the "closed" position. See Figure 7.
Cranking the Engine
Figure 8
1. Place the unit on the ground. Grip the
engine cover with your left hand and
the starter handle with your right hand
(shown).
. Pull the starter handle slowly toward
you until you feel the starter mechanism
engage.
3. Start the trimmer by pulling the starting
handle rapidly outward.
CAUTION!
The recoil starter can be easily dam-
aged by abuse!
n Always engage the starter before
attempting to crank the engine.
n Never pull the starter cord to its full
length.
n Always rewind the starter cord
slowly.
IMPORTANT!
When the Engine Starts or Fires
1. Open the choke by moving the choke
lever backward (toward the fuel tank).
. If the engine does not continue to run,
repeat the appropriate cranking proce-
dures for a cold or warm engine.
3. When the engine starts, clear excess
fuel from the combustion chamber by
accelerating the engine several times
with the throttle lever.
4. Operating the throttle will automatically
disengage the fast idle setting.
WARNING!
The cutting attachment will move when
the engine accelerates!
Operation
n Squeezing the throttle increases engine
speed, causing the clutch to engage and
operate the cutters.
n Releasing the throttle decreases engine
speed, causing the cutters to slow, and
then stop altogether as the clutch disen-
gages.
n Use a sweeping motion when cutting,
and vary throttle settings often.
n Avoid cutting material larger than 1.7
cm in diameter.
If the Engine Does Not Start
n Repeat the appropriate starting proce-
dure for a cold or warm engine.
n If the engine still fails to start, use the
procedures for "Starting a flooded en-
gine," on the next page.