Fastening Tool; Noise Information And Vibration Values - Hilti GX 2 Manual Del Usuario

Status
One LED blinks green.
One LED blinks green.
4 Technical data

4.1 Fastening tool

Weight (empty)
Application temperature, ambient temperature
Maximum fastener length
Fastener diameter
Compression stroke
Magazine capacity in strips of 10 nails (Magazine capac-
ity)
Maximum fastener driving frequency (Fasteners per hour)
Maximum magnetic field strength
Frequency

4.2 Noise information and vibration values

The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one fastening tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the fastening
tool. However, if the fastening tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
estimation of the level of exposure should also take into account the periods of time when the tool is not
actually in use. This may significantly reduce exposure over the total working period. Prescribe additional
safety measures to protect the operator from the effects of noise and/or vibration, such as: maintenance of
the direct fastening tool and its additional equipment or accessories, keeping the hands warm, organization
of work patterns.
Noise emission values determined in accordance with EN 15895
Emission sound pressure level at the workplace
(L )
pA, 1s
Peak sound pressure level at the workplace (L
Sound (power) level (L
Sound level uncertainty
Recoil
Energy-equivalent acceleration, (a
Uncertainty
5 Loading the fastening tool
5.1 Equipment required for driving nails
Nails are fed through the magazine in strip form (ready-to-use strips of nails).
5.2 Loading the magazine
1. Pull the nail pusher back until it engages.
Printed: 11.09.2017 | Doc-Nr: PUB / 5336064 / 000 / 02
)
WA, 1s
)
hw, RMS(3)
Meaning
• Charge status is below 10 %. The fastening tool
is ready for operation.
• The fastening tool is overloaded or overheated
and thus not ready for operation.
3.9 kg
−10 ℃ ...45 ℃
39 mm
• 2.6 mm
• 3.0 mm
20 mm
1 ...4
1,200
−7.6 dBµA/m
13,553 MHz ...13,567 MHz
96 dB(A)
) 130 dB (C)
pC, peak
100 dB(A)
2 dB(A) / 2 dB(C)
Results for 1 mm sheet metal on C40 con-
crete: 3.69 m/s
2
0.22 m/s²
English 19