Maintenance And Environmental Protection - Meister VacBooster MVB 1000 Traducción De Las Instrucciones De Servicio Originales

5465000-Nass-Trock-man.qxd
IMPORTANT: If you suction up
large amounts of liquid, do not
immerse the nozzle completely in the
liquid; allow a separation distance at
the tip of the nozzle opening so that air
can flow in. The device is equipped
with a float valve which ends the
suction procedure when the container
has reached its maximum capacity.
You will notice an increase of the
motor speed. If this happens, switch
off the device, pull the power plug and
pour the liquid into a suitable container
or drain. In order to continue
suctioning, place the drive head again
on the container. Switch off the device
after the wet suctioning, and pull the
power plug. Empty the container, and
clean and dry the inside and outside
before storage.
CAUTION! The foamed material
filter must be removed after wet
suctioning and a reusable textile filter
must be inserted before dry
suctioning.
C Blowing
This wet/dry suction unit is provided
with a blower. To use the blower, follow
the instructions below.
CAUTION! Always wear
protective goggles when you use
the blower.
CAUTION! Keep those present
away from whirling foreign
bodies.
CAUTION! Wear a dust mask.
1. Pull out power plug (Fig. 8C-1).
2. Make sure that the container is empty
68
before you employ the blower.
29.09.2009 10:19 Uhr
3. Pull the hose from the suction
4. Insert the wider end of the hose into
5. Place the required attachment on the
6. Make sure that the mains switch is
7. Hold the loose end of the hose tightly
9 – Maintenance and
A Cleaning
1. Pull out power plug (Fig. 9A-1).
2. Pull the suction hose from the suction
3. Loosen the close-off straps and lift
4. Clean the collection container and the
5. Clean or replace the filters (Fig. 9A-5).
6. Check the suction hose, the
Seite 68
opening.
the blowing connection (8) at the rear
side of the motor head (Fig. 8C-2).
hose (Fig. 8C-3).
switched off, and connect the mains
cable to the power supply (Fig. 8C-4).
before you switch on the wet and dry
suction unit. Switch on the motor by
setting the switch to the ON position "I"
(Fig. 8C-5).
environmental protection
opening (Fig. 9A-2).
the motor head from the container
(Fig. 9A-3).
suction hose of any dirt or foreign
bodies (Fig. 9A-4).
attachments and the mains cable in
order to ensure that they have not
been damaged.
IMPORTANT! Clean the filters
regularly in mild soap solution for