Maintenance Schedule - geberit ACO 201 Instrucciones De Servicio

Operating status
Signal tone sounds six
times and red LED flashes
Red LED lights up and
signal tone sounds six
times
Pressing tool stops and no
LED lights up
After the pressing operation
Operating status
Green LED flashes

Maintenance schedule

Interval
Regularly
20
Operating instructions ACO 201
Cause Actions
Stop button was • Press stop button
pressed or pressing tool • Press start button: Roller drive moves to its
was not in starting
position • Repeat the pressing operation
Pressing tool is • Press stop button
overloaded. The • Press start button
pressing systems • Only use permitted pressing systems, see Use
processed were not • Repeat the pressing operation
approved
Pressing tool is faulty • Press stop button
• Press start button
• If this is not successful, take the pressing tool
Accumulator is faulty • Have the accumulator checked and renew it if
• Press start button
• Press stop button
• Press start button again: Roller drive moves to
• Repeat the pressing operation
Cause Actions
Accumulator is not Charge the accumulator or renew it
charged up sufficiently
for a further pressing
operation
An inspection sticker on the pressing tool indicates the date when the
next service is due. The pressing tool must always be sent in for
maintenance together with the pressing jaws and the battery charger
in its transport case.
For information about authorised specialist workshops, please
contact your responsible Geberit sales company directly or visit
www.geberit.com.
Maintenance work
• Check the pressing tool and accumulator for externally visible defects
and damage that could affect safety
• Clean and lubricate the pressing tool
• Clean and lubricate pressing jaws/adapters and pressing collars/
MapressMAM jaw adapters: see operating instructions of the particular
system
starting position
to a service centre for checking
necessary
its starting position