Specifications - Hydraulic Power Source; Pre-Operation; Operation - Burndy PAT4PC834-LI Instrucciones De Seguridad, Funcionamiento Y Mantenimiento

SPECIFICATIONS - HYDRAULIC
POWER SOURCE
The internal hydraulic power source achieves high
pressure during normal operation. Do NOT disassemble
this tool at any time. Disassembly of this tool may result
in severe personal injury or tool damage, and will void
the warranty.
The hydraulic power system is located internally within
the tool and is a non-field serviceable item. If you suspect
that your tool is not functioning properly, please contact
the BURNDY® Tool Service Center at: 1-800-426-8720.
PRE-OPERATION INSTRUCTIONS
Read and follow all PRE-OPERATION and safety
instructions provided for your PAT4PC834-LI and for the
battery charger (see Charger Instruction Manual) and
accessories. Failure to follow the proper operating
instructions and safety information provided can lead to
serious personal injury or death.
Before operating your PAT4PC834-LI, carefully read and
follow these PRE-OPERATION instructions to ensure your
tool is in proper working condition. Read and follow the
Battery Charger Instruction Manual included for operating
your battery charger unit. Following these instructions,
charge the battery(s).
1. With a fully charged battery installed, depress the
upper trigger first to make certain that the tool ram is fully
retracted.
NOTE: The battery will normally lose energy even when
not in use. To maximize the crimp cycles available from
a battery, ensure the battery is fully charged before
operating.
2. Insert a charged battery into the tool handle. The battery
will only insert in the proper orientation. The battery will
snap into place securing the battery to the tool.
Please note that it is not necessary to have a battery installed
in the PAT4PC834-LI in order to retract the tool ram.

OPERATION

Read and follow all PRE-OPERATION and
safety instructions provided for your
PAT4PC834-LI and for the battery charger
(see Charger Instruction Manual) and
accessories. Failure to follow the proper
operating
information provided can lead to serious
personal injury or death.
Tools is NOT insulated for use on or near
energized conductors. Use of these tools
near energized conductors may lead to
electrical shock, causing severe injury or
death.
Pinch point hazard. Crimp ram operates
at high speed and force and can cause
severe personal injury. Keep all body parts
away from moving parts of the tool during
operation.
WRONG
Certain small connectors when not properly positioned,
can severely damage this tool by becoming wedged
between the indenters and the tool head. See the figures
above for the correct placement of the connector.
NOTE: Do not immerse the tool in water, as it is not
designed to operate under water. This is considered abuse
and will void the warranty! Always use the tool lanyard
provided to prevent dropping the PAT4PC834-LI.
instructions and safety
RIGHT
5