Luxur Y-Lift; Power Recliner Operating Instructions - La-Z-Boy Luxury-Lift Instrucciones De Operación

Luxur y-Lift

Batter y Backup Assembly Instructions:
WARNING
– To reduce the risk of serious injur y:
• In the event of a power failure the batter y backup provided may not
lift the user to a fully raised position.
• In the event of a power failure, if you require a lift to the fully raised
position or multiple lifts and recline, a batter y backup system may be
purchased separately. Contact your La-Z-Boy
• Replace the Power Transformer batteries ever y six months and after
each power failure use.
Batter y Backup Assembly Instructions
In the event of a power failure the batter y backup should return the user to
the seated position from a fully raised position or a full recline position, one time.
The Batter y Backup is located in the Power Transformer and uses two 9-volt
alkaline batteries (not included).
1. Unplug the Power Transformer from the electrical outlet and disconnect the
Power Transformer connection at the base of the chair.
2. Remove the two Phillips head screws from the batter y cover on top of the
Power Transformer.
3. Place the connection caps over the batter y terminals on each batter y.
Place the batteries in the Power Transformer (F
4. Place the batter y cover over the batteries and secure with the two Phillips
head screws removed in Step 2 (F
5. Proceed to the Operating Instructions.
F 1
IGURE
(2) 9-Volt
Alkaline
Batteries
Power
Transformer
Battery
Cover
12
® Power Recliner
® dealer for more information.
1).
IGURE
2).
IGURE
F 2
IGURE
Luxur y-Lift ®
Operating Instructions:
DANGER
– To reduce the risk of serious injury or death:
• Do not let children play on or near the chair when in use. Serious injur y
or death could occur if head or body parts are under the chair arms
when the chair is moved from the full lift to the seated position.
• Plug directly into a wall outlet. Do not use an extension cord or adapter.
WARNING
– To reduce the risk of serious injury:
• The lift chair is intended for a single occupant, not exceeding 500
pounds. Do not operate the chair with more than one occupant in or
on any part of the chair.
• Sit down in the unit slowly. To avoid tip over, do not throw your weight
against the back of the unit. Move the unit into or out of the reclining
position slowly, making sure that no children or pets are in close proximity.
NOTICE:
To prevent product damage operate this chair only
when it is upright, setting on its base.
The automatic homing feature returns the lift chair to the seated position after
the power is restored following a power interruption. This feature may cause
the lift chair to move slightly when plugged in. Connect the Power Transformer
connector to the connector at the base of the lift chair. Plug the Power
Transformer into a wall outlet.
Luxur y-Lift ® Power Recliner Operation
Remove the hand wand from the outside arm pocket.
• To use the power assistance feature to sit in the chair, stand beside the
chair and press the toggle lever toward the UP position on the hand
wand. Release the toggle lever when the chair reaches a comfortable
height to sit against, depending on your personal needs and preference.
Step back into the chair and sit in the center of the seat while keeping
your feet firmly on the floor. Press the toggle lever toward the DOWN
position on the hand wand to lower the chair. Release the toggle lever
when you reach the seated position.
• The legrest extension is separate from the back recline, allowing you to
raise the legrest without reclining the back. To extend the legrest, press
the toggle lever toward the DOWN position on the hand wand. Release
the toggle lever when the legrest reaches a comfortable height.
• To recline the back, press the toggle lever toward the DOWN position on
the hand wand. Release the toggle lever when you reach the desired
recline position.
• To return the back to the upright position from the recline position, press
the toggle lever toward the UP position on the hand wand. Release the
toggle lever when the back is upright.
• To lower the legrest, press the toggle lever toward the UP position on the
hand wand. Release the toggle lever when you reach the seated position.
• To use the power assistance feature to exit the chair, firmly position your
feet to maintain balance and prevent sliding or falling. Press the toggle
lever toward the UP position to raise the chair, to stop movement of the
chair release the toggle lever. When the chair reaches a height that
enables you to comfortably stand release the toggle lever and carefully
exit the chair.
(Operating Instructions Continued)
Power Recliner
13