HAMPTON BAY 21401 Guía De Uso Y Mantenimiento

PACKAGE CONTENTS
A
Assembly and Installation
1
Attaching and installing the
light
IMPORTANT: Do not install the light within 10 ft.
(3 m) of a pool, spa, or fountain.
□
Attach the fixture head (A) to the post (B)
by inserting the fixture head (A) into the
upper end of the post (B) and then twisting
clockwise.
□
Attach the post (B) to the stake (C) by
inserting the bottom of the post (B) into the
top of the stake (C) and twisting clockwise.
□
Push the stake assembly into the ground by
grasping the post. Do not push on the light.
B
D
NOTE: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
B
2
□
□
A
□
□
C
Use and Care Guide
Part Description
A Fixture head
B Post
C Stake
D Connector
C D
Connecting the wires
CAUTION: The wire from the low voltage power
unit shall be 12-16 AWG type underground Low
Energy Circuit Cable.
IMPORTANT: Protect the wiring by routing it in
close proximity to the light, fitting, or next to a
building structure such as a house or a deck.
IMPORTANT: Do not bury the wiring by more
than 6 in. (15.24 cm) in order to connect to the
main secondary wire.
IMPORTANT: Do not submerge in water. This
product could be damaged.
Detach and place the wire connector (D) on opposite sides of the low voltage cable
where the fixture will be located.
Align and fit the main low voltage cable vertically in the slot of the wire connector
as shown.
Press the wire connector (D) together until fully seated and locked around the cable.
Pre-set prongs will pierce the cable insulation and establish contact. Turn on the
power unit. If the light fixture does not turn on, repeat operations 2 and 3.
Once the clip-on connector is in place, wrap it with electrical tape (not included) for
additional protection.
1
Please contact 1-855-HD-HAMPTON for further assistance.
Item #1000 xxx xxx
Model #21401
Path Light
Quantity
1
1
1
1
D
HAMPTONBAY.COM