Safety Instructions - K2 Pumps UTT05001K Manual Del Usuario

PERFORMANCE
Model
UTT05001K

SAFETY INSTRUCTIONS

This pump is non-submersible and should only be used with clear water.
Before start-up:
The pump must be plugged into a GFCI protected outlet which has been installed according to the National Electric
Code and all local codes. The outlet must have a supply voltage of 120 VAC at 60 Hz.
DANGER
Failure to follow these warnings will result in death or serious injury and/or property damage.
ELECTRICAL SHOCK HAZARD.
This pump is non-submersible. Keep the motor dry at all times. Do not wash the motor or submerse the pump in water.
Protect the motor from wet weather. Do not allow any part of cord or receptacle ends to sit in water or in damp locations.
FIRE/EXPLOSION HAZARD.
Pump clear water only with this pump. Do not pump chemicals, corrosive liquids, flammable or explosive fluids such as
gasoline, fuel oil, kerosene, etc. Do not use in a flammable and/or explosive atmosphere.
WARNING
Hazardous Voltage, can shock, burn or cause death.
RISK OF ELECTRIC SHOCK.
1. BE CERTAIN the pump is unplugged before you install, service, or maintain the pump. Never handle a pump
with wet hands or when standing on wet or damp surface or in water.
2. Connect this pump to a properly grounded 115-volt circuit equipped with a Ground Fault Circuit Interrupter
(GFCI) outlet. Never use an extension cord.
3. Before installing this product, have the electrical circuit checked by an electrician to ensure proper grounding. All
electrical installations must conform to the National Electric Code and all local codes.
4. These pumps are supplied with a 3-prong grounded plug to help protect you against the possibility of electrical
shock. DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN.
5. Protect electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the cord. Replace
pump if cord is damaged.
6. Do not lift the pump by the cord. Always use the handle to lift the pump.
7. This pump is not intended to be permanently installed outdoors. Protect pump from extreme heat, cold, and
humidity. This pump is not waterproof and is not intended to be used in showers, saunas, swimming pool areas,
or other potentially wet locations. The motor is designed to be used in a clean, dry location with access to an
adequate supply of cooling air. Ambient temperature around the motor should not exceed 104°F (40°C).
2
GPH of Water @ Total discharge pressure psi
HP
0
1/2 1500
10 20 30
1100 900 650
For Professional Technical Support call 1-844-242-2475
Max.
discharge
pressure
40
50PSI
360