Installation Instructions - K2 Pumps UTT05001K Manual Del Usuario

INSTALLATION INSTRUCTIONS

1. Attach plastic pipe or reinforced heavy-duty hose to the
INLET on the pump. Make sure the Inlet connection is air
tight. Attach the Hose Strainer to the other end of the pipe or
hose to prevent debris from entering the pump.
NOTE: Regular garden hose should not be used on the pump
Inlet. It will collapse when the pump runs.
2. Attach a standard 3/4" garden hose to the OUTLET on the
pump. Keep the total length of hose as short as possible for
best performance. Secure the hose to keep it from moving
around.
3. Remove priming plug from the top of the pump.
4. Fill pump housing with clean water. Reinstall plug.
DO NOT RUN DRY.
NOTE: Do not pump sand or other abrasives as this will damage
the shaft seal or impeller and void the warranty.
For Professional Technical Support call 1-844-242-2475 5