Oras Ventura 8065 Manual De Instalación página 14

INSTALLATION AND MAINTENANCE GUIDE
General
This Installation and Maintenance Guide introduces the operation, installation and use of the faucet.
Please read the instructions carefully prior to installation and save them for reference where servicing
may be needed. If any fault or malfunction occurs in the faucet, please seek the best possible advice at
an expert HVAC store.
Primary places of use
Households, private shower facilities.
Note! Installation of the faucet requires concealed inlet pipes. Connect the inlet water supplies, so that
hot water comes to the left and cold water to the right. N.B. Inlet water supplies must not be cross-
connected.
Operation
Switching the shower on
Press the on/off button (1) to switch the shower on, and water will start to flow from the handshower.
The upper or handshower can also be switched on directly by pressing the button for the upper or
handshower (2, 3).
Switching the shower off
Press the on/off button (1) to switch the shower off. The shower will automatically switch off after the
maximum flow period.
Flow-rate adjustment
Flow-rate can be adjusted with the right-hand side buttons (4, 5). If the flow-rate is already at its
maximum/minimum value, the shower emits an audio signal. The shower offers 7 different flow-rates
and the factory default is 80 per cent.
Temperature adjustment and display
The shower is equipped with a thermostatic cartridge. There is a safety button on the temperature
adjustment knob(6); the knob is below the membrane panel. To raise the water temperature above
38°C, press the button and turn the knob simultaneously. The temperature display is at the bottom end
of the panel.
Safety function
The temperature adjustment knob is equipped with a safety button. If the water temperature from the
upper shower is over 44°C, the water flow will automatically switch to the handshower.
Flow period
The shower automatically switches off after the maximum flow period (5 min.) is up and an audio signal
sounds 10 seconds before that. Press the on/off button(1) again after the audio signal for another
maximum period shower.
Changing the factory settings (figure 1)
– The factory settings of the shower can be modified using the buttons on the membrane panel.
– Set the shower in its modification mode by pressing both flow-rate adjustment buttons (4, 5) simulta
neously.
– Select the parameter to be modified with the upper/handshower buttons (2, 3) and confirm it by
pressing the on/off button. There is a dot after the parameter number.
– Modify the parameter as desired with the upper/handshower button and confirm the change with the
on/off button (1).
– Exit the modification mode by pressing both flow-rate adjustment buttons (4, 5) simultaneously.
14
GB