Control Of Hob Burners - SUNFEEL CO4462WB Instrucciones De Uso

4. USE OF YOUR PRODUCT
Flame safety device:
Hob Burners (If your hob is equipped with gas safety device)
Hobs equipped with flame failure device provide security in case of accidentally extinguished flame.
If such a case occurs, the device will block the burners gas lines and will avoid any accumulation
of unburned gas. Wait 90 seconds before re-igniting an extinguished gas burner
Oven / Grill Burners
Regardless of the model of your appliance, all oven burners are equipped with a gas safety device.
For this reason, during ignition, keep the oven knob pressed until you see stable flames. If the
flames are cut out after you release the knob, repeat the procedure again. If the oven burner does
not ignite after you keep the burner knob pressed for 30 seconds, open the oven door and do not
attempt re-ignition for at least 90 seconds. When oven flames go out accidentally, repeat the same
procedure .
4.1.1 Control of the hob burners
OFF position
The knob has 3 positions: Off (0), maximum (big flame symbol) and minimum (small flame symbol).
After you ignite the burner in maximum position; you can adjust the flame length between
maximum and min. positions. Do not operate the burners when the knob position is between
maximum and off positions.
Cap
Crown
Spark
Plug
Burner
Cup
MAX. position
After the ignition, check the flames visually. If you see yellow
tip, lifted or unstable flames; turn the gas flow off, and check
the assembly of burner caps and crowns (Figure 20). Also,
make sure that no liquid has flown into the burner cups. If
the burner flame goes out accidentally, turn the burner off,
ventilate the kitchen with fresh air, and do not attempt re-
ignition for 90 sec.
When turning the hob off, turn the knob in the clockwise
direction so that the knob shows "0" position or the marker
on the knob points upwards.
Figure 20
MIN. position
15
.
MODULATE
Figure 19