CREE LIGHTING FLX Serie Instrucciones De Instalación página 3

4
Reset
Button
Motion
Sensor
Ambient Light Sensor /
Blue LED indicator
SmartCast SENSOR
®
(SC1)
5
Loose End Cap
6
7
3 of 5
Motion
Sensor
Ambient Light Sensor /
LED indicator
Reset
Button
LUTRON VIVE SENSOR
(VDO/VRF)
Fixed End Cap
Lens
Emergency
Backup Button
Fixed End Cap
STEP 6:
Luminaires ordered with VD0/VRF are provided with
factory installed Lutron Vive Wirless fixture control. For
set-up programming, troubleshooting with a Lutron
Vive system, please refer to the installation instructions
included with Vive or at www.lutron.com. See Figure 4.
SMARTCAST RESET
®
STEP 1:
Actuate RESET button through the access hole. Press
and hold Reset button until the blue LED flashes fast
(approximately 5 seconds). See Figure 4.
STEP 2:
Release the Reset button for 1 second (Fast flashing
continues). Press and hold Reset for 1 second until
fast flashing stops. If the blue LED does not respond
with the two-blink sequence, please repeat the RESET
procedure.
CLEANING LENS
STEP 1:
Remove lens and endcap by pulling down gently on one
end near endcap. See Figure 5.
STEP 2:
Before installing lens, ensure that one endcap is already
installed.
STEP 3:
After cleaning is complete, place loose endcap back onto
lens and angle lens into fixed endcap. After getting lens
seated into fixed endcap, rotate upwards to engage loose
endcap into position. See Figure 5. Lens may need to be
squeezed together to help guide into pan.
STEP 4:
Confirm there are no visible gaps along entire length of
lens and around endcaps. If necessary, push endcaps
against end panel or lens against luminaire to eliminate
gaps
NOTE: If fixed endcap comes loose during removal, push
upwards while using end panel as a stop to engage clips
See Figure 7.
LPN00437X0007A0_A