Publicidad
Idiomas disponibles
Idiomas disponibles
Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your system or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury.
warns about hazards that will cause death,
serious personal injury, or major property damage if
ignored.
warns about hazards that can cause death,
serious personal injury, or major property damage if
ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
Carefully read and follow all safety instructions in this
manual and on equipment. Keep safety labels in good
condition; replace if missing or damaged.
1058 0594
For parts or assistance, call Flotec Customer Service at
Hazardous suction.
Can trap and tear
hair or body parts.
Can cause drowning.
Do not play with cleaner
or hose or apply to body.
Do not let children use or
play with pool cleaner.
Stop pump before
attempting to clean unit.
Oscillator may
injure hands or fingers. Stop
pump before attempting to
clean out pool cleaner head.
Hose can trip
or entangle swimmers.
Do not allow swimmers in
pool while pool cleaner is
operating.
ABOUT SAFETY
Before installing the cleaner, review and understand all
warnings and safety information on inside cover of manual.
Read and understand all installation information.
ABOUT YOUR POOL
AND FILTER SYSTEM
Before installing your cleaner, review and under-
stand all warnings and safety information on the inside
front cover of this manual.
Pre-installation check list
Before installing the cleaner in a vinyl liner pool:
Check liner closely for signs of deterioration or damage
from age, chemicals, pool wall damage, etc. If any dam-
age is found, have a qualified pool professional make all
necessary repairs. Also, if there are stones, roots, etc.,
under the liner, remove them before installing the cleaner.
Before installing the cleaner, clean your filter system:
Make sure you have cleaned the filter, including back-
washing, rinsing, and emptying all baskets. A clean system
is necessary for proper cleaner operation and coverage.
Before installing the cleaner, fill the hose with water:
Always make sure the cleaner head is submerged and
the hose is full of water before connecting the hose to
the filtration system (whether through a skimmer or dedi-
cated wall fitting). Air in the system can damage the
pump through dry running and overheating.
ABOUT MAINTENANCE AND CARE
Hazardous suction. Stop pump before
attempting to clean pool cleaner.
Keep skimmer basket and pump strainer basket clean
and free of debris.
If cleaner jams with large debris (leaves, sticks, etc.), try
cleaning debris first from bottom of unit. If this doesn't
clear unit, remove top swivel assembly (turn 1/4 turn)
and clear the debris from the top.
Remove the pool cleaner from the pool before super
chlorinating (shocking) or chemical balancing. Wait at
least four hours after the chemical procedure before rein-
stalling the cleaner.
Make sure that the cleaner's brush bristles don't become
deformed during storage. Store the unit so that it doesn't
sit on the bristles and so that nothing compresses them.
If possible, do not coil the hose. Store it flat and straight.
If necessary to remove oscillator, see "Oscillator
Removal", Page 8.
1-800-365-6832
2
Publicidad
