Arregui RESIST Manual De Instrucciones página 7

Thank you for purchasing this RESIST safe. We advise you to read the
instructions before you install and use the safe to prevent its improper
use from making the guarantee void.
A. CHARACTERISTICS OF THE PRODUCT
This safe is meant to protect your objects of value and your documents
in the event of a possible fire. Due to its heavy weight, it is advisable to
place it on firm flooring.
FRONT DIAGRAM OF THE SAFE:
1
B. OPENING AND CLOSING THE RESIST SAFE
B.1. BATTERIES INSTALLATION AND OPENING
• Extract the battery compartment located outside the safe, at the lower
part of the keyboard, and place 4 alkaline batteries of 1.5 V.
• Press the * key. A beep sounds and a green LED flashes.
• Enter opening code ( initial master-code is 1-2-3-4-5-6)
• Every key pressing is confirmed with a beep sound and a green led
flashing. If the key is not pressed over the course of 10 sec. the lock will
switch off and the operation must be repeated.
• Press ENTER
• While the green led is flashing, turn the handle counter clockwise and
open the door.
• If the typed code is incorrect 2 beeps sounds and a red LED flashes
during 5 seconds. In this case, start the operation again.
• The safe allows up to 3 erroneous code entries before it is blocked for
5 minutes as a security measure. During this time, it is not possible to
use the keypad. During the blocking period the red LED on the keyboard
flashes in 5 seconds intervals.
WARNING:
• For your own security, it is recommended to change the opening code
as soon as you open the safe for the first time (see point C)
2
1. KNOB.
2. NUMERIC KEYPAD.
3. BATTERIES COMPARTMENT
3
<EN>