Cable Connections - Hughes & Kettner Tube Tools REPLEX Manual

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

B) TUBE CIRCUITRY:
When driven at higher levels, tubes generate a very soft and
musical brand of distortion. The response of tubes to the level
of input signals is highly complex - they compress signals and
generate a rich spectrum of overtones.
2. JACKS AND CONTROL FEATURES

2.1. CABLE CONNECTIONS

NOTE: The best point in the signal chain at which to connect
the REPLEX to your amp is immediately before it. While it is
theoretically possible to insert the REPLEX into a post-preamp
effects loop, doing so would make little sense in tonal terms.
INPUT: Plug your guitar into this input jack.
OUTPUT: Connect the output jack of the REPLEX to the guitar
input jack of your amp.
2.2. KNOBS
DRIVE: Establishes the input impedance (gain) and thereby the
degree of tube distortion.
SAT: The SAT LED lights up when the tube is driven to its
saturation threshold and the signal is just beginning to break
up.
OUTPUT: Controls the output level of the REPLEX.
REVERB VOLUME: Controls the level of the reverb effect.
VOLUME: In Single Head mode, controls the level of the delay
effect. In Dual Head mode, controls the level of the first
simulated head.
FEEDBACK: Controls the intensity of feedback and thus the
number of repetitions that the delay generates.
VINTAGE FACTOR: Simulates the complex sound-shaping
effects of magnetic tape recordings and controls their
intensity. The more you turn the knob, the more intensely these
factors will color the sound.
SINGLE HEAD TIME: In Single Head mode, controls delay time.
In Dual Head mode, controls delay time of the first simulated
head.
DUAL HEAD TIME: Controls the delay time of the second
simulated head in Dual Head mode.
DUAL HEAD VOLUME: Controls the level of the second
simulated head in Dual Head mode.
2.3. SWITCHES
Note: The pedal's Reverb and Delay sections operate
independently, i.e. you cannot operate both at the same time.
BYPASS: Switches the effect on and off. This is a true hardwire
bypass. That is, when the Replex is switched off (green LED off),
the signal at the input is routed directly to the output, absolu-
tely unaffected by the internal circuitry.
REVERB: Switches the reverb effect off or on.

Publicidad

Tabla de contenido
loading

Tabla de contenido