Safety Instructions - Tool it DBT 300 Traducción De Las Instrucciones Originales

Translation of the original instructions

SAFETY INSTRUCTIONS

This manual includes guidelines on the operation of your
device and the precautions to follow for your own safety.
Ensure it is read carefully before first use and keep it
handy for future reference.
Risk of explosion and fire!
A battery being charged can emit explosive gas.
The battery tester should only be connected to batteries
with a rated output voltage of 12 V.
CAUTION: Reverse polarity will cause the fuse to blow
and could cause permanent damage. Damage due to
reverse polarity is not covered by our warranty.
CAUTION: If the car's battery is disconnected, some
management systems may be disabled.
Consult your vehicle manual for more information on
installation.
Do not use the battery tester if the cord or terminals are
damaged.
Do not use the battery tester if it has received a severe
shock or has been damaged in any way.
Do not disassemble the device. Incorrect reassembly may
result in a risk of electric shock or fire.
Acid projection hazard!
• Wear appropriate safety glasses and clothing.
• If your eyes or skin come into contact with battery acid,
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery against
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Material conforms to UK requirements. The UK
• Device compliant with Moroccan standards.
• The C‫( م‬CMIM) declaration of conformity is available
• This product should be disposed of at an appropriate
• Recyclable product that falls within waste sorting rec-
CONNECTING THE BATTERY TESTER
1- Make sure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries (and START & STOP 12 V batteries) and test of the
charging system.
3- Before performing a test on the battery, make sure that the ignition and the
consumers are switched off.
Close all doors and the boot.
4- Make sure that the battery connections are clean. If necessary, clean them
with a wire brush.
The presence of oxydation between the tester terminals and the battery
connectors or between the connectors of the battery and the terminals de-
creases the tester efficiency.
5- Connect the negative (black) terminal to the negative terminal of the battery.
Connect the positive terminal (red) to the terminal positive of the battery.
6
rinse the affected part of the body with plenty of water
and seek immediate medical assistance.
short-circuiting.
Declaration of Conformity is available on our website
(see cover page).
on our website.
recycling facility. Do not dispose of in domestic waste.
ommendations
DBT 300
EN