Safety Instructions - Tool it NBT 200 Manual De Instrucciones

Ocultar thumbs Ver también para NBT 200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
Translation of the original instructions

SAFETY INSTRUCTIONS

This manual includes guidelines on the operation of
your device and the precautions to follow for your
own safety. Ensure it is read carefully before first use
and keep it handy for future reference.
Risk of explosion and fire!
A battery being charged can emit explosive gas.
The battery tester should only be connected to batteries
with a rated output voltage of 12 V.
CAUTION: Reverse polarity will cause the fuse to blow
and could cause permanent damage. Damage due to
reverse polarity is not covered by our warranty.
CAUTION: If the car's battery is disconnected, some
management systems may be disabled.
Consult your vehicle manual for more information on
installation.
Do not use the battery tester if the cord or terminals are
damaged.
Do not use the battery tester if it has received a severe
shock or has been damaged in any way.
Do not disassemble the device. Incorrect reassembly
may result in a risk of electric shock or fire.
Acid projection hazard!
• Wear appropriate safety glasses and clothing.
• If your eyes or skin come into contact with battery
acid, rinse the affected part of the body with plenty
of water and seek immediate medical assistance.
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery against
short-circuiting.
• The device complies with European Directive.
• The certificate of compliance is available on our
website.
• EAC conformity mark (Eurasian Economic Commission)
• Material conforms to UK requirements. The UK
Declaration of Conformity is available on our
website (see cover page).
• Device compliant with Moroccan standards.
• The C‫( م‬CMIM) declaration of conformity is
available on our website.
• This product should be disposed of at an appropri-
ate recycling facility. Do not dispose of in domestic
waste.
• Recyclable product that falls within waste sorting
recommendations
CONNECTING THE BATTERY TESTER
1- Make sure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries.
3- Before running a test on the battery, ensure that the ignition and the consu-
mers are switched off. Close all doors and the boot.
4- Make sure that the battery connections are clean. If necessary, clean them
with a wire brush.
Any presence of oxidation between the tester terminals and the battery
connectors or between the battery connectors and the battery terminals re-
duces the effectiveness of the tester.
NBT 200
EN
5

Publicidad

Tabla de contenido
loading

Tabla de contenido