Maintenance; Application Area; Storage Conditions; Trouble Shooting - Dexter 20VOS2-125.1 Instrucciones Legales Y De Seguridad

6. MAINTENANCE

The orbital sander and charger is designed for using and charging in temperature regions with a
characteristic temperature of 0 ° C to 50 ° C, relative humidity not more than 80%,the absence of
direct exposure to atmospheric pre capitation and excessive dust content of the air.
Requirements for room conditions
Do not use power tools in explosive areas where flammable liquids, gases, dust are present. It creates
sparks, which can lead to the ignition of dust, steam.
Shelf life - 4 years provided that the products are stored indoors with natural ventilation in the
package at an air temperature of --20 ° C to 40 ° C and a relative humidity of not more than 80%

7.TROUBLE SHOOTING

Problem
The machine stops working
after rotating slowly.
Sparking visible through the
housing air vents
Selecting the correct grit of sandpaper is an important step in achieving optimum results. Coarse
grit will remove the most material. Finer grit will produce a smoother finish. The condition of the
workpiece will determine the grit of the sandpaper to be used. The higher the grit number, the finer
the grade of sandpaper.If the surface is rough, start with a coarse grit and sand until the surface is
uniform. Medium grit may then be used to remove scratches left by the coarser grit. Finer grit is then
used to finish the surface. Always continue sanding with each grade of sandpaper until the surface
is uniform.

Application area

Storage conditions

Possible Causes
The battery is in low power.
A small amount of sparking
may be visible through the
housing vents.
Sandpaper Selection
Likely solutions
Need to charge the battery
pack before operating
This is normal and does not
indicate a problem.
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN
191