Function Display - Milltronics pointek ULS200 Guía Para La Puesta En Marcha Rápida

Output Function
The alarms can be set to function in the desired mode.
Function
1 *
2
3
4
5
6
7
8
9
10
11
12
13
14
* Factory setting

Function display:

high alarm
high-high alarm
low alarm
low-low alarm
loss of echo alarm
pump up control
pump down control
Setpoints
The setpoints can be set where reference levels,
either from the material in the vessel or from a
target, cannot be provided. This method can also
be used to trim the output levels obtained by the
Reference Method (Quick Start).
The setpoints are referenced from the face of the
sensor. They should not be set at or above the
blanking value, or at or below the range limit.
Factory Setting: Relay 1 = 0.5 m (1.64 ft)
Relay 2 = 4.50 m (14.76 ft)
7ML19981XB81
Relay 1
high alarm low alarm
high alarm high alarm
low alarm low alarm
high alarm LOE alarm
low alarm LOE alarm
pump down low alarm
pump down high alarm
pump up low alarm
pump up high alarm
pump down LOE alarm
pump up LOE alarm
pump down
pump down pump down
pump up
H
HH
L
high-high
LL
high
LOE
PU
PD
low
low-low
ULS200
setpoint
Pointek ULS200 – QUICK START MANUAL
Relay 2
pump up
pump up
on setpoint
blanking
range
limit
Page EN-13