Promise Technology FASTTRAK TX4660 Guia De Inicio Rapido página 9

To connect the FastTrak card to your server:
1. Install the disk drives into the open drive bays of your system.
2. Attach a SFF-8087-to-SFF-8087 SAS data cable (not included) to one of the
Ports on the FastTrak card. See Figures 1 and 2.
3. Attach the other end of the SAS data cable to the midplane connector in the
server.
Refer to the server's setup guide or user manual for more information.
Using a SuperSwap Enclosure
The FastTrak TX4660 and TX8660 cards have internal SAS Ports and are
designed to work with the SuperSwap enclosure.
For instructions on installing the SuperSwap enclosure and the disk drives, refer
to the SuperSwap Quick Start Guide or User Manual.
To connect the FastTrak card using a SuperSwap enclosure:
1. Install the SuperSwap enclosure into your system.
2. Install the disk drives into your SuperSwap enclosure.
3. Do one of the following actions:
• SuperSwap 4600: Connect a SFF-8087-to-SATA fanout data cable (not
included) to one of the Port connectors on the FastTrak card.
Attach the No. 1 SATA connector to the Port 1 connector on the
SuperSwap.
Connect the remaining SATA connectors to their matching Ports on the
SuperSwap.
• SuperSwap 1600: Connect a SFF-8087-to-SATA fanout data cable (not
included) from one of the Port connectors on the FastTrak card.
Attach a SATA connector to the Interface connector on the SuperSwap.
Repeat this action for each SuperSwap enclosure in your system.
4. Attach one end of the three-wire management cable (included with
SuperSwap) from the SMBus connector on the FastTrak card to the
Management connector on the back of the SuperSwap.
The SuperSwap enclosure does not use the LED pins on the FastTrak card.
Use of removable physical (disk) drive enclosures other than
Promise Technology's SuperSwap is not supported and may result
in performance loss or other undesired results.
Task 3: Connecting the TX4660 and TX8660
Caution
9