Kobalt SGY-AIR166 Manual De Instrucciones página 12

ASSEMBLY INSTRUCTIONS
6. Connect air supply hose to the male plug (L).
Set the working pressure at 90 PSI for best tool
performance.
NOTE: Working pressure refers to the air line
pressure applied to tool when tool is under
working conditions.
1/4 IN. AIR ROTARY TOOL
7. Remove the air inlet protective cap from the
air inlet (J2).
8. Mount a male plug (L) by hand into the
air inlet (J2).
NOTE: Use thread sealant tape on the male plug
and tighten it with a wrench (not included) for
airtight connection. Do not overtighten.
6
7
8
12