Operating Instructions - Kobalt SGY-AIR166 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
12. Tighten the collet jacket (B2) clockwise with the
large wrench (E) while holding the small
wrench (F) on the flats of the collet holder (C2).
Make sure that the grinding stone is installed
securely and tightly.
Only use grinding accessories that have an RPM
rating equal to or greater than the tool itself.
13. Connect air supply hose to the male plug (L).
Set the working pressure at 90 PSI for best
tool performance.
NOTE: Working pressure refers to the air line
pressure applied to tool when tool is under working
conditions.

OPERATING INSTRUCTIONS

3 IN. AIR CUT OFF TOOL
Push lever (I1) forward and press down on the
trigger (H1) to start the tool.
WA R N I N G
12
13
1
14