GE GPF825 Serie Instrucciones De Instalación página 2

2 REMOVE DOOR PANEL
Figure 2
• Open dishwasher door.
• Remove the 6 Phillips head screws along the
sides of the door (Figure 2) holding the inner
door to the outer panel. Retain screws.
3 ASSEMBLE PANEL AND TRIM FRAME
• Remove the protective plastic covering from
the top, sides and the front trim frame pieces.
Top Trim Screws
Figure 4
• Remove the 3 screws holding the top trim to
the steel panel (Figure 4). Set aside the top
trim piece and the 3 screws.
Slide
Panel
Into
Frame
• Slide the 1/4" custom panel into the channel
between the trim and the steel panel (Figure 5).
• Remove the two screws on the bottom of the
door panel (Figure 3). Retain screws.
• Remove door panel.
• Loosely assemble the top trim to the steel
panel with the 3 original screws.
Figure 6
Top
View
• Place the assembled panel, appearance side
down on a flat protected surface. Be careful
Custom
not to scratch the custom panel or the trim.
Panel
• Loosen one of the 4 screws that holds the
steel panel to the trim (Figure 6). Press the
steel panel against the custom panel and
retighten the screw. Repeat this adjustment to
the remaining 3 screws.
• Press the top trim piece flush against the
Figure 5
custom panel and tighten all 3 top trim
screws.
2
Bottom
Phillips Screws
Figure 3
Panel Adjustment Screws