Team kalorik TKG FT 1008 Manual Del Usuario página 12

Fax +32 2 359 95 50

Only use the appliance for deep-frying. Only cook friable and

consumable foodstuffs.
Housing, inner bowl, lid, basket and handle can be washed by

hand. Never immerse the appliance or its control panel in water or
any other liquid for cleaning or for any reason whatsoever (see
"Cleaning" section).
Wait until the appliance is completely cool before moving,

cleaning or storing it. Always take the appliance by the carrying
handles. Always unplug the appliance before handling it.
Never operate the appliance without oil or fat in it. Ensure that the

oil or fat level is always between the minimum and maximum
marks inside the bowl. Never overfill as hot oil or fat might be
ejected.
It is absolutely necessary to keep this appliance clean at all times

as it comes into direct contact with food.
Make sure the cord never comes in contact with the hot parts of

the appliance. Be aware never to touch these hot parts.
Make sure the hot parts of the appliance are not exposed to

inflammable materials, such as curtains, tablecloth... as a fire might
occur.
Never cover the appliance with any kind of material.

Never add water to the oil.

It is forbidden to place the lid on the deep fat fryer when it is

in use, as this could cause fire or oil overflow. For this kind of
fryer the lid should only be used for storing and moving (as soon
as the deep fat fryer has cooled down).
CAUTION: the deep fryer can reach high temperatures when in

use. Oil and fat preparations might catch fire if overheated. Be
extremely cautious never to leave your deep fryer in use for long
periods. Do not forget to switch off the appliance once your
preparation is ready and the fryer is no longer in use. Before
pulling the mains plug, switch the temperature selector to the
lowest position ("MIN").
Provide proper ventilation when using the appliance.

If you wish to use solid fat, cut it into small pieces and place them

into the bowl. Turn the temperature knob to its minimum position
("MIN"). Each time the pilot light goes out, turn the temperature
knob to a slightly higher temperature until all the fat has melted.
Once all the fat has melted, set the temperature knob to the
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
12
Assembly page 12/64
TKG FT 1008 - 150421