Fracarro KDF Instrucciones De Funcionamiento página 13

5.3 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the headend
programming menus
HEADEND
SETUP
(Not av ailable)
Automatic
acknowledgement of the
headend connected to
the TPE
(Not available )
Restore the headend
default settings
At the first time of connecting the TPE to the KDF converter, the following menu options will appear: INPUT, OUTPUT and
MEASUREMENTS.
Input parameter
Output parameter
Measurement
parameter
NAVIGATION
OSD NAVIGATION
HEADEND SCAN
COPY
FACTORY SETUP
SET ADDRESS
RESET MODULE
5.4 INITIAL MENU
INPUT
OUTPUT
MEASURES
KDF
programming menu of the KDF
Search Module....
Copy Paste
KDF
KDF
By means of the copy function, you can copy the following input parameters:
LNB, DiSEqC tone, IF freq. and Symbol rate. The output channels, video format,
video test, audio type and audio level.
All
KDF
modules
The factory setup function restores the following factory parameters: LNB,
DiSEqC tone, IF freq., Symbol rate and visualized channel. The restored
output parameters are the following: output frequency, output channel, video
format, video test, audio type and audio level.
Change address
Current: xxx
KDF
All
KDF
modules
INPUT Menu see page
OUTPUT Menu see page
MEASURES Menu see page
13
Ref er to the general
receiver
Automatic search of the headend or
connected device. Af ter searching,
the main menu can be seen using
the NAVIGATION function.
YES=V NO=X
YES=V NO=X
Select the new address
using the up/down
arrows. Conf irm by
New: xxx
pressing the V key .
YES=V NO=X
14
15
15