How to Dry and Steam Iron
w CAUTION
temperature setting or failing to allow the iron to preheat for
2 minutes can result in hot water dripping from the soleplate.
1. To Steam Iron: Make sure Iron is
unplugged and Adjustable Steam Lever
is in Off
Water Reservoir: Slide Water Fill Door
Latch back to release door. Lift Water Fill
Door and add untreated tap water up to
the MAX Fill Line through the opening.
If you have extremely hard water, mix
50% untreated tap water with 50% distilled or demineralized
water for use in the Iron. Press Water Fill Door down to secure
in place. Plug into outlet and the white arrows (
will flash. Press the up (
temperature setting. See recommended Ironing Chart on
page 8. Move Adjustable Steam Lever to On ( ) (Steam Iron).
To Dry Iron: Plug into outlet. Press
up (
) or down (
temperature setting.
2. Preheat 2 minutes to reach desired
temperature. Iron will beep and display
setting will stop flashing when ready.
Make sure Adjustable Steam Lever is in
Off
(Dry Iron) position. You are now
ready to iron.
3. To turn Iron off, move Adjustable Steam Lever to
position and press up (
Unplug.
6
Burn Hazard. Attempting to steam iron on a lower
(Dry Iron) position. To fill
) arrow to select
) or down (
) or down (
/
) arrow to select
(Dry Iron)
) arrow to turn OFF .
)