LG PCS400R Servidor Pro:Centric Instalación Y Configuración página 35

• Test Equipment
In some cases, LG has supplied or recommended the use of test equipment and devices for
the setup and testing of the equipment. The operation and maintenance of test equipment is
described in their associated instruction manuals. Please refer to these manuals for explicit
instructions regarding the safe use and handling of the equipment.
• Damage Requiring Service
Unplug this product from the wall power outlet and refer servicing to qualified service personnel
under the following conditions:
- If the power-supply cord or plug is damaged.
- If liquid has been spilled, or objects have fallen into the product.
- If the product has been exposed to rain or water.
- If the product does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions, as an improper adjustment
of other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to its normal operation.
- If the product has been dropped or the cabinet has been damaged.
- If the product exhibits a distinct change in performance.
- Caution: Refer all servicing to qualified service personnel.
• Servicing
Caution: These servicing instructions are for use by qualified service personnel only. To reduce the
risk of electrical shock, do not perform any servicing other than that described in the operating
instructions unless you are qualified to do so.
• Replacement Parts
When replacement parts are required, be sure the service technician uses replacement parts
specified by the manufacturer or that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
• Safety Check
Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks to determine that the product is in proper operating condition.
• Handling Notice
Caution: Only qualified service personnel should handle and install this unit. A series of
screws with lock washers are used to secure the top and bottom covers of the unit. Use
caution when handling the unit as the lock washers may have rough edges. Do NOT run your
fingers over the top and bottom covers of the unit.
• PCS400R Rack Installation (also see pages 13 to 15)
- Wear a properly grounded, antistatic wrist strap to avoid causing electrostatic (ESD) damage to
the PCS400R.
- Carefully slide the PCS400R into a standard 19-inch equipment rack.
- When mounting in the rack, make sure to use the appropriate hardware. ALL FOUR MOUNTING
SCREWS MUST BE USED.
- This equipment is not designed to support other devices. Do NOT stack other equipment on the
top of the PCS400R.
- Rear cabling must be dressed and supported so that the weight of the cabling is not a strain on
the PCS400R connectors.
- MOUNTING OF THE EQUIPMENT IN THE RACK SHOULD BE SUCH THAT A HAZARDOUS
CONDITION IS NOT ACHIEVED DUE TO UNEVEN MECHANICAL LOADING.
7