6. INSTALL AND FLUSH FILTER CARTRIDGE
Q. Lift handle of the built-in shut off Valve on the
Head.
R. Hold Head firmly with one hand.
S. Align cartridge lug with label on filter Head.
T. Insert filter Cartridge – Push upwards.
U. Turn it to the right – About 1⁄4 turn – Until rotation
stops.
V. Open Side Valve of Angle Stop Adaptor and check
for leaks up to Inlet Elbow Fitting.
W. Open Filtered Water Faucet.
X. Lower handle of built-in shut off valve on the Head,
to flush water to the sink.
NOTE: Flush new filter cartridges for at least
3 minutes (flush H-1200 system for at least 7
minutes) to remove air and any loose carbon. At
first the water may appear cloudy due to trapped
air in the filter and tubing. If water continues to
be cloudy for more than one week, please contact
Everpure Technical Services for assistance.
Y. Activate Filter Timer by pinching bubble until you
feel a change in resistance as the filter timer "pops".
Within a few seconds, a thin RED line will appear in
the white window showing the Timestrip has been
activated. Peel away backing and adhere to desired
location. When the white window is completely filled
with RED, it is time to replace your product.
H-1200 INSTRUCTIONS
Tools Needed For Installation
• #2 Phillips Screwdriver
• Wrench
• Utility Knife
• Measuring Tape
• Pencil
1. OPEN CARTON & INSPECT PARTS
Installation Parts
Key
Description
1
Twin Filter Head
2
H-1200 Filter Cartridges
(Set of 2) (
Includes
3
Locking Washers (2 req.)
4
Screws (2 req.)
5
Angle Stop Valve Adaptor
6
Tubing, 1/4" poly (per foot)
7
Elbow Fitting Pack Restrictor
(incl. Qty. 2 ea of #3 & #4)
8
Plumbers Tape
9
Faucet Connector
10
Everpure Filter Timer
11
Shut Off Valve,
3/8" John Guest x 3/8" FPT
12
Coupler, 3/8" FPT
Stainless
6 • EVERPURE
H-Series Water Filtration Systems
Part No.
N/A
EV928201
)
10
EV306204
EV306196
EV312120
A0860119
EV308168
EV312119
EV312135
EV314160
EV309860
EV312350
6
Q
S
R
T
V
W
Y
1
1
2
Label
Lug
U
X
4
3
5
8
7
6
11
10
12
9